SCPI Command Reference
E4980A/AL commands
Description
Enables DHCP to obtain the IP address from a DHCP server.
This command works with Firmware version 1.0x. Do not use this
command with Firmware version 2.00 or later.
Parameter
ON or 1 (Preset value)
OFF or 0
Equivalent key
[System] - SYSTEM CONFIG - DHCP ENABLED - ON
[System] - SYSTEM CONFIG - DHCP ENABLED - OFF
:SYSTem:COMMunicate:LAN[:SELF]:MAC?
Syntax
:SYSTem:COMMunicate:LAN[:SELF]:MAC?
Description
Returns the MAC address. (Query Only)
Equivalent key
No equivalent key is available on the front panel.
:SYSTem:COMMunicate:LAN[:SELF]:PRESet
Syntax
:SYSTem:COMMunicate:LAN[:SELF]:PRESet
Description
Presets the network settings and restarts the network. (No Query)
Equivalent key
[Preset} - LAN RESET - OK
:SYSTem:COMMunicate:LAN[:SELF]:RESTart
Syntax
:SYSTem:COMMunicate:LAN[:SELF]:RESTart
Description
Restarts the network (No Query)
This is available only for serial prefix number below:
MY464/SG464 and below for E4980A
MY542/SG542 and below for E4980AL
Equivalent key
[System] - SYSTEM CONFIG - DHCP ENABLED - RESTART NETWORK
[System] - SYSTEM CONFIG - AUTO-IP ENABLED - RESTART NETWORK
Keysight E4980A/AL Precision LCR Meter
1. This key is for the firmware revision1.0x
Description
Enables the DHCP function
Disables the DHCP function
1
1
369