Signals Activated When Overload Occurs - Keysight E4980A User Manual

Handler Interface
Using the Handler Interface

Signals Activated when Overload Occurs

Signals activated when overload occurs are as follows. For conditions where
overload occurs, refer to
on page
Table E-15 Signals activated when Overload Occurs
Measurement Parameter that overload occured
Impedance measurement (except for Ls/Lp-Rdc)
Impedance measurement (Ls/Lp-Rdc)
DCR measurement (Ls/Lp-Rdc)
Vdc measurement (primary)
Idc measurement (primary)
Vdc measurement (secondary)
Idc measurement (secondary)
Signals are not output when the limit parameter (LMT field) is OFF during
the list sweep measurement. Signals are not output when the comparator
function (COMP field) is OFF during the measurement other than list
sweep.
-482
"Displaying Errors instead of Measurement Results"
71.
Handler output
(active signal)
/OUT_OF_BINS
/OVLD
/OUT_OF_BINS
/OVLD
/OUT_OF_BINS
/OVLD
/OUT_OF_BINS
/OVLD
/OUT_OF_BINS
/OVLD
normal
normal
Keysight E4980A/AL User's Guide