Configuration Overview; Set Port Mode Commands - 3Com CoreBuilder 5000 User Manual

4-2 C
ONFIGURING THE
Configuration
Overview
Set Port Mode
Commands
M
ODULE
The CoreBuilder 5000 Distributed Management Module (DMM) and the
Advanced DMM/Controller Module provide network management for
the CoreBuilder 5000 hub and its modules. Use network management
commands, rather than the DIP switches, to configure the module. All
of the DIP switch settings on the 12-Port 100BASE-TX Workgroup
FastModule are ignored if an appropriate CoreBuilder 5000 Distributed
Management Module (DMM Version v4.10 or later) is already installed
in the hub.
If network management is present when you first install the module,
the:
Network defaults to isolated mode.
Ports are automatically disabled (so that users cannot join the
network undetected by network management).
Therefore, you must enable the ports you want to use and set the
module ports to the appropriate network using management
commands.
Do not manage (get statistics or configure) this module from a slave
management module.
To enable ports and set the module ports to the appropriate network,
use the following SET PORT MODE commands:
Enable/Disable/Shutdown Ports Command
Setting Port Redundancy Command
Setting Remote Diagnostics Command
Set Port Alert Filter Command
Network Selection