Vlan Commands - D-Link xStack DGS-3426 Cli Manual

The VLAN commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following
table.
Command
create vlan
delete vlan
config vlan
config gvrp
enable gvrp
disable gvrp
show vlan
show gvrp
Each command is listed, in detail, in the following sections.
create vlan
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To create a VLAN v1, tag 2:
DGS-3400:4#create vlan v1 tag 2
Command: create vlan v1 tag 2
Success.
DGS-3400:4#
xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
Parameters
<vlan_name 32> {tag <vlanid 2-4094> | advertisement}
<vlan_name 32>
<vlan_name 32> {[add [tagged | untagged | forbidden] | delete]
<portlist> | advertisement [enable | disable]}
[<portlist> | all] {state [enable | disable] | ingress_checking [enable
| disable] | acceptable_frame [tagged_only | admit_all] | pvid
<vlanid 1-4094>}
{<vlan_name 32>}
{<portlist>}
NOTE: If you are plan to use access control, read the discussion of the access profile
rule limitations in Access Control List (ACL) Commands below.
Used to create a VLAN on the Switch.
create vlan <vlan_name 32> {tag <vlanid 2-4094> |
advertisement}
This command allows you to create a VLAN on the Switch.
<vlan_name 32> − The name of the VLAN to be created.
<vlanid 2-4094> − The VLAN ID of the VLAN to be created. Allowed
values = 2-4094
advertisement − Specifies that the VLAN is able to join GVRP. If
this parameter is not set, the VLAN cannot be configured to have
forbidden ports.
Each VLAN name can be up to 32 characters. If the VLAN is not
given a tag, it will be a port-based VLAN. Up to 4094 static VLANs
may be created per configuration. Only administrator-level users
can issue this command.
103
15
VLAN C
OMMANDS