The VLAN Trunk commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command
enable vlan_trunk
disable vlan_trunk
config vlan_trunk ports
show vlan_trunk
Each command is listed, in detail, in the following sections.
enable vlan_trunk
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable VLAN trunk:
DES-3000 Series Layer 2 Switch CLI Reference Manual
Parameters
[<portlist>|all] state [enable|disable]
Used to enable VLAN trunking on the switch.
enable vlan_trunk
When the VLAN trunk function is enabled, the VLAN trunk ports shall be
able to forward all tagged frames with any VID.
None.
Only Administrator-level users can issue this command.
DES-3026:4# enable vlan_trunk
Command: enable vlan_trunk
Success
DES-3026:4#
VLAN T
128
19
C
RUNK
OMMANDS