Keithley 4200-SCS Reference Manual page 511

Model 4200-SCS Reference Manual
Figure 7-30
KI 7174 Matrix Card Properties tab
Nearly identical (and functionally equivalent) Properties tabs display in the Workspace for other KI
7XXX matrix cards that are supported by the Keithley Instruments Model 707/708.
NOTE
The two areas of a Properties tab define the following connections for a switch-matrix card:
Figure 7-30
support the physical connection configuration that is shown in
Card Properties area
The Card Properties area describes the following:
Rows area
In the Rows area, the combo boxes labeled A through H correspond to the eight rows of all
Keithley Instruments Model 707/708 compatible matrix cards. Use the pull-down menus of the
combo boxes to connect the rows to various instrument terminals.
NOTE
4200-901-01 Rev. S / May 2017
Detailed signal routing and physical matrix connection information for each
supported matrix card is provided in "Controlling a switch matrix" in Section 2 of the
Applications Manual.
• Between the measurement instrumentation and the matrix card
• Between the matrix card and the test system (prober or test fixture)
shows the KI 7XXX matrix-card Properties tab configuration that is required to
• Model Full vendor name, model number, and card description
• Slot Switch matrix slot that the matrix card is installed in
Prober or test-fixture pins are always connected to matrix-card columns.
Return to Section Topics
Section 7: Keithley CONfiguration Utility (KCON)
Figure 7-27.
7-35