Keithley 4200-SCS Reference Manual page 293

Model 4200-SCS Reference Manual
Figure 6-208
Specifying the probe-location site number through the Site Navigator
3.
Figure 6-209
Selecting a test for execution
4.
Figure 6-210
KITE Run Test/Plan button
Figure 6-211
KITE Test/Plan Abort button
NOTE
4200-901-01 Rev. S / May 2017
a. Place the probe at the site that contains the ITM or UTM to be evaluated.
b. Using the Site Navigator (located above the Project Navigator), scroll to the number of
the site where you placed the probe in step 2a (use the spin buttons). See
Figure 6-208.
In the Project Navigator, select the name of the ITM or UTM to be executed. For example,
consider the execution of an ITM in the u_build Project Plan (created under
modifying, and deleting a Project
id" ITM in the 4terminal-n-fet_2nd_in_subsite Device Plan.
Start execution. Click the green triangular Run Test/Plan toolbar button, select Run in the
KITE Run menu, or press the F6 keyboard key.
The green Run Test/Plan toolbar button becomes gray, the ITM or UTM executes, and the
square Abort Test/Plan icon illuminates red for the duration of the test (see below).
If you should need to abort the ITM or UTM execution, click the red Abort Test/Plan
toolbar button or press the PAUSE/BREAK keyboard key.
Return to Section Topics
Section 6: Keithley Interactive Test Environment (KITE)
Spin buttons
Plan). Figure 6-209
Building,
shows selection of the second "vds-
6-167