Keithley 4200-SCS Reference Manual page 196

Section 6: Keithley Interactive Test Environment (KITE)
• Above and below ITMs and other UTMs. The instructions in this subsection reflect adding
For illustration purposes, the UTM name will be added to the u_build Project Plan below a
Device Plan. See
Figure 6-72
Selecting the device in which to insert a new UTM name
2. Do either of the following:
• In the Project menu, click New User Test Module.
• In the Project Plan toolbar, click the Add New UTM button. See below.
Figure 6-73
Add New UTM button
The Add New User Test Module (UTM) to Project dialog box appears. See
Figure 6-74
Add New User Test Module (UTM) to Project dialog box
3. In the Add New User Test Module (UTM) to Project dialog box, enter the desired name for
the UTM. For the u_build Project Plan, the user library to be later connected to the UTM
measures the drain-to-source resistance for the FET at saturation. Therefore, the name
res_drain-to-source is typed in. See
Figure 6-75
Entering a new UTM name
6-70
the UTM below an ITM or UTM.
Figure 6-72.
Return to
Figure 6-75.
Section Topics
Model 4200-SCS Reference Manual
Figure 6-74.
4200-901-01 Rev. S / May 2017