Keithley 4200-SCS Reference Manual page 194

Section 6: Keithley Interactive Test Environment (KITE)
2. Do either of the following:
• In the Project menu, click New Interactive Test Module.
• In the Project Plan toolbar, click the Add New ITM button. See below.
Figure 6-69
Add New ITM button
The Add New Interactive Test Module (ITM) to Project dialog box appears. See
Figure 6-70
Add New Interactive Test Module (ITM) to Project dialog box
3. In the Add New Interactive Test Module (ITM) to Project dialog box, type the name for the
completely new ITM. The name charg_char was entered as the new ITM for the capacitor
in the u_build Project Plan.
4. Click OK. The new, as yet unconfigured, ITM is added to the Project Plan. See
Figure 6-71
Completely new ITM added to the Project Plan
Editing the ITM insertions
For information on editing your ITM insertions, refer to
later in this
Inserting the UTMs
In contrast to ITMs, relatively few UTMs are presently provided by Keithley Instruments in the
C:\S4200\kiuser\Tests library. If these are insufficient, you must initially create additional
UTMs (which you can subsequently submit to C:\S4200\kiuser\Tests or to a personal
library). The following steps summarize the required approach.
1. Insert a new UTM into the Project Plan only by name.
2. Connect the name of the UTM to an existing KULT created user library and user module
through a UTM Definition tab.
3. In the UTM Definition tab, edit/enter the required parameters.
6-68
section.
Return to Section Topics
Model 4200-SCS Reference Manual
Rearranging and deleting ITMs and UTMs
4200-901-01 Rev. S / May 2017
Figure 6-70.
Figure 6-71.