Table of Contents
Advertisement
Model 4200-SCS Reference Manual
3.
4.
CAUTION
5.
Understanding and using Append worksheets of a Sheet tab
The optional Append feature appends (layers) curves from multiple runs on a single graph and
creates a separate worksheet for each Append execution. Refer also to
tests, test sequences, and Project Plans
graph
Understanding Append worksheets
The following applies to the worksheets that are created by Append executions:
NOTE
See
4200-901-01 Rev. S / May 2017
In the Save in edit box of the Save As window, select the location for the comma delimited
text file.
In the File name edit box of the Save As window, Keithley recommends that you add a
modifier to the displayed file name. In that way, the name both retains the data-source
identifier and identifies the worksheet type. For example, you might save the vds-id#1@1
worksheets as follows:
• The Data worksheet as vds-id#1@1-Dat.
• The vds-id#1@1 Calc worksheet as vds-id#1@1-Clc.
• The vds-id#1@1 Settings worksheet as vds-id#1@1-Stg.
• The Append worksheets, if any, as vds-id#1@1-Ap1, vds-id#1@1-Ap2,... and so on.
For a given test, the default filename that is displayed in the "File name"
box (the data-source-identifier name) is the same for all of the worksheets.
However, when you specify the comma-separated-values format (*.csv),
KITE attempts to save each of the worksheets as a separate file. Therefore,
you must give each of the worksheets a separate filename (preferably by
adding a worksheet-specific modifier to the default filename). Otherwise,
the save of one worksheet will overwrite the save of another.
Click Save.
•
The data generated for each Append execution of a test is located in an individual Append
worksheet, where n designates the nth Append execution. That is, the worksheets are
labeled Append1, Append2, ..., and so on.
You can specify the maximum number of Append executions and worksheets (the
maximum value of "n"). After the maximum number of Append worksheets have
been generated, the data from each Append execution replaces the data from the
previous Append execution. For example, if the maximum value of "n" is 4, the data
from the fifth Append execution replaces the data from the fourth Append execution.
Refer also to
Append execution of tests, test sequences, and Project Plans
•
Each Append worksheet is labeled with a separate tab to distinguish it from the Data
worksheet for the test.
•
Each Append worksheet contains the same columns and rows as the Data worksheet for
the test.
•
Each Append worksheet may be manipulated in the same way as the Data worksheet for
the test.
Figure
6-231.
Return to
Section 6: Keithley Interactive Test Environment (KITE)
and
Appending curves from multiple runs on a single
Section Topics
Append execution of
6-181
Advertisement
Chapters
Table of Contents
