Itm Output Values; Configuring The Utms - Keithley 4200-SCS Reference Manual

Section 6: Keithley Interactive Test Environment (KITE)

ITM Output Values

The measured readings for an ITM test can export (output) to a Subsite Data sheet for subsite
cycling. The exported readings for an ITM test are called Output Values.
Each time a subsite is cycled, the measurements for the enabled output values are placed in the
Subsite Data sheet. If for example, the subsite is cycled five times, there will be five measured
readings (Output Values) for the ITM test. See
subsite cycling.
Exporting Output Values: In the Project Navigator, double-click the desired ITM to open it. On the
Definition tab, click the Output Values button (see
is shown in
that an ITM can have up to 20 Output Values.
NOTE
Figure 6-159
Exporting ITM Output Values to the Subsite Data sheet

Configuring the UTMs

After inserting ITMs and UTMs into your Project Plan, they must be configured to meet your test
requirements. This subsection describes connection of Project Plan UTMs to user modules and
user libraries and entering/editing of module parameters. ITM configuration was discussed
previously under
A Project Plan UTM is configured using the following main steps:
1. Open a UTM window for the Project Plan UTM.
2. Connect/reconnect the name of the UTM to an existing KULT created user module through
the UTM Definition tab of a UTM window.
3. In the UTM Definition tab, enter the required parameters.
4. Configure, or change, Formulator calculations, if any.
5. Save the configuration.
These steps are illustrated graphically in
subsections:
• Opening a UTM window
• Connecting/reconnecting the UTM to a user library and module
6-142
Figure 6-159. The two steps to export Output Values are shown in the drawing. Note
The measured readings for UTMs can also be exported to a Subsite Data sheet. See
UTM Output Values.
Configuring the Project Plan
Return to
Subsite cycling later in this section
Figure
1) Insert a check mark for the Output Values
that you want to export into the Subsite Data
sheet. Clicking a checkbox inserts or deletes a
check mark.
2) Click OK.
ITMs.
Figure 6-160 and are discussed in detail in these next five
Section Topics
Model 4200-SCS Reference Manual
for details on
6-4). The ITM Output Values window
4200-901-01 Rev. S / May 2017