Keithley 4200-SCS Reference Manual page 339

Model 4200-SCS Reference Manual
The four tabs of the Axis Properties window are used as follows:
Naming the axes
When you first open a Graph tab and specify the variables to be plotted, the default axis names
(titles) are the same as the Data sheet column headings in row 1. If there are multiple sets of data
with the same parameter names, the default axis names are the column headings for set #1, for
example, DrainI(1) and DrainV(1).
1.
Figure 6-251
X Axis tab
NOTE
2.
3.
4.
9. The Graph axes of some library ITMs may already be labeled more appropriately. For example, a DrainV(1) column
4200-901-01 Rev. S / May 2017
• X Axis: Controls properties of the horizontal axis.
• Y1 Axis: Controls properties of the left vertical axis.
• Y2 Axis: Controls properties of the right vertical axis.
• All Axes: Controls certain properties that are common to all axes.
In the Graph tab Axis Properties window, open the X Axis, Y1 Axis, or Y2 Axis tab, as
appropriate, by clicking on the tab label. The tab opens.
Alternatively, right-clicking on an axis displays the corresponding axis tab.
In the Text edit box, type the new name (title) for the axis, preferably including
measurement units. For example, for the X axis of the vds-id graph you might type
Drain Voltage (V).
In the Rotation combo box, specify a different orientation for the axis name (title) if the
default orientation is not desired. The angle is specified relative to the X axis. By default,
axis names are parallel to and facing the axes: 0 degrees for X, 90 degrees for Y1, and 270
degrees for Y2.
Name the other axes by repeating steps 1 through 3.
label in the Data worksheet may have already been converted to a Drain Voltage (V) axis label in the Graph tab.
Return to
Section 6: Keithley Interactive Test Environment (KITE)
9
To rename an axis, do the following:
Section Topics
Figure 6-251 shows the X Axis tab.
6-213