Lpt Functions For The Model - Keithley 4200-SCS Reference Manual

Model 4200-SCS Reference Manual
tstdsl Test station deselect
Purpose
Format
Remarks
NOTE
Example
See also
Test station select
tstsel
Purpose
Format
Remarks
NOTE
See also
LPT functions for the Model 4205-PG2
The following information explains the functions included in the Keithley LPTLib (Linear Parametric
Test Library) for the 4205-PG2 pulse generator card. The functions are summarized in
NOTE
NOTE
4200-901-01 Rev. S / May 2017
Used to deselect a test station.
tstdsl (void);
To relinquish control of an individual test station, a new test station must now be
selected using tstsel before any subsequent test control functions are run.
The tstdsl command has the same effect as the tstsel (0) command.
tstdsl is not required for use in a UTM.
/* Disables test station.*/
tstdsl ( );
tstsel
Used to enable or disable a test station.
tstsel (int x);
Where x is the test station number, 0 or 1.
tstsel is normally called at the beginning of a test program.
tstsel (1) will select the first test station and load the instrumentation configuration.
tstsel is not required for use in a UTM.
tstdsl
All pulse functions are supported by the 4205-PG2 pulse generator card. Most
pulse functions are also supported by the 4200-PG2 if the firmware is upgraded to
KITE 6.2. Instructions for upgrading firmware are available by clicking the
Complete Reference icon on the 4200-SCS desktop. Follow the links for Release
Notes, then look for the Firmware Upgrade Procedure for the pulse card firmware.
The terms "pulse generator card" and "PG2" is used for functions that pertain to
both the 4205-PG2 and 4200-PG2. Operations that are not supported by the
4200-PG2 are explained.
Return to Section Topics
Section 8: Keithley User Library Tool (KULT)
Table 8-11.
8-155