Gpib Command Set - Keithley 4200-SCS Reference Manual

Model 4200-SCS Reference Manual
Graphing the test results
If you have sent the needed graphics commands, the DM1 command followed by the X axis and Y
axis configuration commands, KXCI displays a graph of the generated data. See the example
graph and highlighted graphics commands in
Figure 9-9
Data graph
NOTE

GPIB command set

GPIB commands to control instrument operation are divided into four categories:
4200-901-01 Rev. S / May 2017
KXCI plots all Y1 axis curves in red and all Y2 axis curves in blue. You can temporarily
hide the graph by clicking the Hide Graph button.
• Page commands: KXCI locates the GPIB instrument control routines in various pages that
are similar to the HP Model 4145B command pages. Consequently, before sending an
instrument control command string, you must send the appropriate page command. The
page commands are summarized in
• System mode commands: This comprehensive set of commands uses all of the source-
measure capabilities of up to eight SMUs installed in the 4200-SCS. These commands are
summarized in Table
• User mode commands: This limited set of commands perform basic source-measure
operation. These commands are summarized in
• Common commands: These commands are valid in any operating mode. These
commands are summarized in
• 4200 extended mode-only commands: These commands are specific to the 4200
extended mode (not usable in the 4145 emulation mode). They are summarized in
Table 9-5.
Return to
Section 9: Keithley External Control Interface (KXCI)
Figure
Table 9-1.
9-2.
Table 9-4.
Section Topics
9-9.
Table 9-3.
9-11