Keithley 4200-SCS Reference Manual page 188

Section 6: Keithley Interactive Test Environment (KITE)
Figure 6-54
Adding an ITM to the Test Sequence Table
8. If, under Test Sequence Table, an ITM is not at the preferred position in the sequence, do
this:
a. Select the ITM to be moved.
b. Use the Move Up button or the Move Down button to reposition the ITM.
9. In the Device Plan window, below the list of ITMs, click the Apply button. The ITM is added
to the Project Navigator. See
Figure 6-55
Library ITM inserted in the Project Plan using the default library name
Inserting a library ITM using a new name
You may insert an ITM from the library anywhere in the same Project Plan under a new name. A
renamed ITM is independent of the originally named ITM. Therefore, a renamed ITM can be
custom-configured to meet the specific test requirements of the device with which it is associated.
To insert a library ITM using a new name, do the following:
1. Select the Device Plan under which to insert a renamed ITM. For the u_build Project Plan,
a second, somewhat modified n-FET, the 4terminal-n-fet-2nd_in-subsite, was selected.
See
Figure 6-56
Selecting the location for a second "vds-id" ITM for the u_build Project Plan
2. Open the Device Plan, select a test library, and select a test as described in steps 2 through
6 of
u_build Project Plan, the "vds-id" ITM was selected from the default test library,
C:\S4200\kiuser\Tests
6-62
Figure 6-56.
Inserting a library ITM using the "default" library name earlier in this
.
Return to Section Topics
Figure 6-55.
Model 4200-SCS Reference Manual
section. For the
4200-901-01 Rev. S / May 2017