Keithley 4200-SCS Reference Manual page 678

Section 8: Keithley User Library Tool (KULT)
Figure 8-110
pulse_fall
See also
Example
pulse_halt Stops pulse output
Purpose
Format
Remarks
See also
Example
8-162
V High
(100%)
V Low
(0%)
The pulse fall time setting takes effect immediately during continuous pulse output.
Otherwise, the fall time setting takes effect when the next trigger is initiated. The
function is used to trigger continuous or burst output.
pulse_trig
NOTE Use the
pulse_source_timing
Models 4220-PGU and 4225-PMU.
pulse_rise
For fast speed, the following function sets the pulse fall time for channel 1 of the PG2 to
50 ns:
pulse_fall(VPU1, 1, 50e-9)
This function stops all pulse output from the PG2.
int pulse_halt(INSTR_ID instr_id)
instr_id
This function stops all pulse output from the PG2 and turns the PG2 channels off. Pulse
output can be restarted by first turning the outputs back on with
then using the
pulse_trig
pulse_output
The following function stops PG2 pulse output:
pulse_halt(VPU1)
Return to Section Topics
Fall
Time
function to set the pulse fall time for the
Instrument ID of the PG2: VPU1, VPU2, and so on.
function to restart the test.
Model 4200-SCS Reference Manual
and
pulse_output
4200-901-01 Rev. S / May 2017