Keithley 4200-SCS Reference Manual page 29

Model 4200-SCS Reference Manual
Table 1-2 (continued)
Reference Manual synopsis
Section
number/
letter
2
3
4
5
6
7
8
9
10
11
12
13
14
4200-901-01 Rev. S / May 2017
Section title
Installation
Source-measure hardware Describes the 4200-SCS source-measure hardware in more detail,
Connections and
configuration
Source-measure concepts
Keithley Interactive Test
Environment (KITE)
Keithley CONfiguration
Utility (KCON)
Keithley User Library
Tool (KULT)
Keithley External Control
Interface (KXCI)
System administration
Pulse source-measure
concepts
Pulse projects
KPulse
KScope
Return to Section Topics
Description
Covers unpacking and inspection, system connections, basic SMU
connections, and power and environmental requirements.
Provides a brief summary of the pulse generator card and scope
card.
including the following:
• Physical: Front and rear panel interfaces. Instrument terminals
and connectors for the 4200-SCS mainframe, 4200-SMU,
4210-SMU, and 4200-PA (preamp).
• Needed services and environmental conditions. Mounting
options for the preamp.
• Electrical: Block diagrams, operating characteristics, and basic
connections for the 4200-SCS mainframe, 4200-SMU,
4210-SMU, and 4200-PA (preamp).
Provides details for basic source-measure connections, external
test equipment connections, and control and data connections.
Describes various source-measure concepts, including guarding,
sensing, sink operation, source-measure configurations, and
sweeping. Covers how to make stable measurements, and low-
current measurements, and discusses possible sources of
interference.
Explains and illustrates the characteristics and operation of KITE.
Some topics covered include the Project Navigator, ITMs, and
UTMs. Explains how to run tests and view and analyze data.
Explains how to use this utility to add components (switch matrix,
test fixture, C-V analyzer, pulse generators, and probe station) to
the test system. Also provides diagnostic and troubleshooting
information for the 4200-SCS.
Explains how to use this tool to create and manage libraries of
user modules.
Explains how to use an external controller (computer) to control
(by means of GPIB or ethernet) the SMUs, pulse generator cards,
and a single scope card of the 4200-SCS remotely. It also explains
how to execute user modules created in KULT remotely.
Explains basic system administration operations. These include
software upgrades, interfacing with networks and printers, limiting
system access, and other operations.
Provides documentation for using Keithley pulse cards and a
4200-SCP2 or 4200-SCP2HR (digital storage oscilloscope card) to
perform pulse source-measure tests.
Provides the documentation for the Keithley Instruments pulse
projects. Describes the tests (ITMs and UTMs) for each project.
The KPulse graphical user interface is used to control the Keithley
pulse cards. This is also in Section 5 of the User's Manual.
Explains how to use the graphical user interface (GUI) that is used
to control the 4200-SCP2 or 4200-SCP2HR digital storage
oscilloscope.
Section 1: Introduction
1-9