Using Kxci - Keithley 4200-SCS Reference Manual

Model 4200-SCS Reference Manual

Using KXCI

To start GPIB operation, start KXCI. The 4200-SCS is ready to accept GPIB commands
immediately after you start KXCI (for command information, refer to
command
Logging commands, errors, and test results
When you send GPIB commands, KXCI logs the commands, error messages, and test results as
follows:
Figure 9-6
Command display
4200-901-01 Rev. S / May 2017
reference, Ethernet command
• When you send a command:
- The left side of the user interface (the command and message display area) displays
each command as it is received. See
- If the Console Logging Enabled check box is selected, KXCI also logs each command
into the KXCI log file (C:\S4200\sys\KXCI\KXCILogfile.txt).
• The command and message display area displays error messages as they occur.
• The command and message display area also displays the numerical test results, both in
the 4200 extended mode and 4145 emulation mode (refer to
Figure 9-8.
Return to
Section 9: Keithley External Control Interface (KXCI)
reference, and
Figure 9-6.
Section Topics
GPIB command
Pulse generator and scope
Section 7). See
set, GPIB
commands).
Figure 9-7 and
9-9