Connecting A Lan; Smu Connections - Keithley 4200-SCS Reference Manual

Model 4200-SCS Reference Manual

Connecting a LAN

The two LAN connectors on the 4200-SCS are standard RJ-45 connectors intended for use with
UTP (Unshielded Twisted Pair) cable. For best results, use only CAT 5 UTP cables equipped with
RJ-45 connectors to connect your LANs, as shown in
Figure 2-5
LAN connections

SMU connections

The following information explains how to connect the source-measure units (SMUs) to the device
under test (DUT):
WARNING
CAUTION
If optional preamps were ordered with your 4200-SCS, they have already been installed on the
rear panel. All tests should be performed using the preamps, because the installed SMUs were
optimized at the factory to use them.
4200-901-01 Rev. S / May 2017
Model 4200-SCS
GNDU
S
COM E
INSTRUMENT
N
S CONNECTIONS
E
SMU ONLY
SENSE LO
GUARD
SENSE LO
LPT O
R
C COMMON
E
SMU AND GNDU
C
SENSE
O
M
M
GUARD COMMON
O
N
ORCE
K E I T H L E Y
28775 AURORA RD.
CLEVELAND, OH 44139
MADE IN
USA
KEITHLEY
4200
TM
INTLK
C
IN
OUT
C
LAN Connectors
Do not touch test cables or connectors when powering up the 4200-SCS.
Hazardous voltage may be output momentarily, posing a safety hazard
that could result in personal injury or death.
Do not turn on the 4200-SCS until you have reviewed the safe power-up
procedure described in
Do not connect the DUT to the Model 4200-SCS before powering it up,
because the hazardous voltage that may be output momentarily at
power-up could damage the DUT.
Return to Section Topics
Figure 2-5.
INSTRUMENTS
SLOT SLOT SLOT SLOT SLOT SLOT
4
KEITHLEY
KEITHLEY KEITHLEY KEITHLEY KEITHLEY
420 4200 4200 42 0 42 0
PG2 SCP2HR C U SMU SMU
SENSE LO SENSE LO SENSE LO
C
HCUR
SENSE SENSE
E
T
T
O
E
HPOT
ORCE ORCE
C
2
LPOT
C 2
T
I
LCUR
PA CNTRL PA CNTRL PA CNTRL
CAT 5 UTP Cable LAN Junction
Box or Hub
Powering the Model
Section 2: Installation
SLOT SLOT
2
KEITHLEY KEITHLEY
4200 4200
SMU SMU
SENSE LO
SENSE SENSE
ORCE ORCE
PA CNTRL
4200-SCS.
2-7