Keithley 4200-SCS Reference Manual page 563

Model 4200-SCS Reference Manual
Example
Update the ki590ulib library (in the active user-library directory), which depends on the
Winulib library.
C:\>kultupdate ki590ulib -dep Winulib
Copying user libraries using kultcopy
The kultcopy utility copies any user library from any accessible storage location to the active
user-library directory. More specifically, kultcopy does the following:
NOTE
Usage
kultcopy <library_name> [options]
Options
Any of the following options may be placed at the [options] position in the command:
4200-901-01 Rev. S / May 2017
• Copies the user library that is specified by the "Start-In" user-library directory, which is the
directory in which you start the kultcopy command. Refer to the NOTE below, to the
example below, and to
To successfully copy a user library to the active user-library directory, you must
start kultcopy in the following directory:
<source_lib_path>\<source_lib_name>\src
This directory is called the "Start-In" directory, where:
<source_lib_path> is any accessible user library directory.
•
<source-lib-name> is the name of the specific user library to be copied.
•
For instructions on changing the destination directory (%KI_KULT_PATH%), refer to
Changing the active user-library directory
• Performs kultupdate so that the user library is immediately ready for use (refer to
Updating user libraries using kultupdate
•
-dep <library_dep_1>...[library_dep_6]
Specifies up to six libraries upon which library_name depends.
•
-hide
Hides library_name so that it is not visible in KITE.
•
+hide
Unhides library_name so that it is visible in KITE.
Return to
Changing the active user-library directory
earlier in this section.
earlier in this section).
Section Topics
Section 8: Keithley User Library Tool (KULT)
earlier in this section.
8-47