Keithley 4200-SCS Reference Manual page 195

Model 4200-SCS Reference Manual
NOTE
If, after creating a UTM, you submit it to C:\S4200\kiuser\Tests or to a personal library, you
can subsequently insert it from this library in the same way as an ITM.
This subsection covers the following topics:
CAUTION
Table 6-4
Shared and unique characteristics for same-named Project Plan UTMs
Characteristics that are shared between all
instances of a Project Plan UTM having the same
name. A change of one instance changes the
definition of all instances identically.*
Everything on the Definition tab for the UTM, except
for the parameter settings. The shared
characteristics include the following:
• The specified user library
• The specified user module
• All Formulator formulas*
• Output Values.
* Changing the user module or the user library causes all Formulator formulas to be deleted.
Inserting a completely new UTM
If a UTM of a desired type does not already exist in a test library, you must enter a new UTM into a
Project Plan only by name, then connect it to, and configure it for, an existing user module.
When initially building a new Project Plan, it may be convenient to add all new UTMs first without
immediately connecting them to user modules; this allows you to focus on Project Plan structure
without becoming distracted with configuration details.
NOTE
Insert a new, name-only UTM into a Project Plan as follows:
1.
4200-901-01 Rev. S / May 2017
Connecting a UTM name with a user library and user module and entering the
required parameters is discussed subsequently under
this section.
• Inserting a completely new UTM
• Inserting a library UTM
• Editing the UTM insertions
If you need to insert multiple instances of an UTM under the same name,
be sure that you understand the rules that apply. Review
However, if you intend to insert additional instances of a new UTM under the same
name, you must first connect it to a user module and then insert the additional
instances from the test library. For information about connecting a UTM to a user
library, refer to Configuring the UTMs later in this
submitting a UTM to a test library, refer to
libraries later in this
In the Project Navigator, select the component below which (or in some cases, above
which) you'll insert the UTM. You can insert UTMs at the following places:
• Below Device Plans, initialization steps, and termination steps.
Return to
Section 6: Keithley Interactive Test Environment (KITE)
Characteristics that are unique to each instance
of a Project Plan UTM having the same name. A
change of one instance has no effect on any
other instance.
• The parameter settings
• Test data
• Formulas in the Calc worksheet of the Sheet tab
• Plot settings in the Graph tab
• The Unique IDentifier number (UID)
Submitting devices, ITMs, and UTMs to
section.
Section Topics
Configuring the UTMs later in
Table 6-4
section. For information about
below.
6-69