Segarbconfig - Keithley 4200-SCS Reference Manual

Section 8: Keithley User Library Tool (KULT)

SegARBConfig

The SegARBConfig is the most complex control type available for the UTM GUI view. The
®
capability has many parameters, with most of them in arrays. This control type provides the
ARB
interface to user modules making use of two specific LPT commands:
page 8-208
Segment ARB GUI view:
• UTM GUI Parameter Configuration dialog (shown
dialog that you can use to configure the SegARBConfig control.
• Segment ARB Defaults Configuration dialog (shown in
dialog that you can use to configure the channel's sweep values.
Figure 8-74
SegARBConfig UTM GUI Parameter Configuration dialog
Control type for
parameter display:
SegARBConfig
Group for this parameter
Segment ARB Defaults
(opens another dialog)
For this control type, the PMU_SegArb_ExampleFull user module is used in the example (see
Figure 8-14R). This module is included in the PMU-DUT-Examples project (in the _Pulse project
folder) as the UTM PMU_SegArb_Complete
configuration control as the only control in the group. You can add other controls, but there can be
only one Segment ARB control in a group.
8-80
and "seg_arb_waveform" on page
Brief help for
Tooltip text, which is displayed when
this dialog
mouse pointer is hovered over the
control (in the UTM GUI View)
Return to Section Topics
8-210. There are two dialogs that configure the
Figure 8-74). This dialog is the primary
Figure
Configure each segment ARB parameter
by assigning each parameter (such as
SegTime) with the user module variable
name in the drop-down list.
For a valid Segment ARB configuration, For a valid Segment ARB configuration,
assign these Segment ARB arguments assign these Segment ARB arguments
to user module variables to user module variables
(Figure 8-75). Figure 8-75
Model 4200-SCS Reference Manual
Segment
"seg_arb_sequence" on
8-82). This is the second
shows the Segment ARB
4200-901-01 Rev. S / May 2017