Keithley 4200-SCS Reference Manual page 734

Section 8: Keithley User Library Tool (KULT)
Table 8-25 (continued)
Code status or error titles
Code
-704
-705
-706
-707
-801
-802
-803
-804
-805
-806
-807
-808
-809
810
-811
-812
-820
-821
-822
-823
-824
-825
-826
-827
-828
-829
-830
831
-832
-833
-834
-835
-836
-837
-838
-839
-840
-841
-842
-843
8-218
Status or error titles
Error reading serial port.
Timeout reading serial port.
Terminator not received before read buffer filled.
Error closing serial port %s.
Exception code %d reported from VPU in slot %d, channel %d.
VPU in slot %d has reached thermal limit.
Start and stop values for defined segmented arb violate minimum slew rate.
Function not valid in the present pulse mode.
Too many points specified in array.
Not enough points specified in array.
Function not supported by 4200-VPU.
Solid state relay control values ignored for 4200-VPU.
Time Per Point must be between %g and %g.
Attempts to control VPU trigger output are ignored by the 4200-VPU.
Measure range not valid for %s.
WARNING: Sequence %d, segment %d. Cannot measure with PGUs/VPUs.
PMU segment start value %gV at index %d does not match previous segment stop value of
%gV.
PMU segment stop time (%g) greater than segment duration (%g)
PMU sequence error for entry %d. Start value %gV does not match previous stop value of
%gV.
Start and stop window was specified for PMU segment %d, but no measurement type was
set.
Measurement type was specified for PMU segment %d, but start and stop window is invalid.
%s set to post to column %s. Cannot fetch data that was registered as real-time.
Cannot execute PMU test. No channels defined.
Invalid pulse timing parameters in PMU Pulse IV test.
Maximum number of segments per PMU channel exceeded (%d).
The sum of base and amplitude voltages (%gV) exceeds maximum (%gV) for present range.
Pulse waveform configuration exceeded output limits. Increase pulse period or reduce
amplitude or total time of pulsing.
Maximum number of samples per channel (%d) exceeded for PMU%d-CH%d.
Pulse slew rate is too low. Increase pulse amplitude or reduce pulse rise and fall time.
Invalid trigger source for PIV test.
Invalid pulse timing parameters.
Using the specified sample rate of %g samples/s, the time (%g) for sequence %d is too short
for a measurement.
WARNING: Sequence %d, segment %d is attempting to measure while solid state relay is
open. Disabling measurement.
No RPM connected to channel %d of PMU in slot %d.
Timing parameters specify a pulse that is too short for a measurement using %g samples/s.
Timing parameters contain measurement segment(s) that are too short to measure using %g
samples/s.
SSR cannot be opened when using RPM ranges. Please change SSR array to enable relay
or select PMU measure range.
WARNING: SSR is open on segment immediately preceding sequence %d. Measurement
will be invalid for 25 us while relay settles.
This test has exceeded the system power limit by %g watts.
Step size of %g is not evenly divisible by 10 ns.
Return to Section Topics
Model 4200-SCS Reference Manual
4200-901-01 Rev. S / May 2017