Keithley 4200-SCS Reference Manual page 185

Model 4200-SCS Reference Manual
Inserting ITMs from a test library
Insert a library ITM into your Project Plan from the default test library in C:\4200\kiuser\Tests
or an equivalent personal test library such as C:\4200\YourName\Tests. Such a library
typically includes the standard set of ITMs that come installed on the Model 4200-SCS, as well as
any custom ITMs that you have submitted (the submittal procedure is discussed under
tests to a library later in this
Factory-supplied library ITMs, if unmodified, are preconfigured with commonly used parameter
settings and are usually accompanied by a set of typical data for illustration purposes. Custom
library ITMs are also often preconfigured, though for special requirements. When appropriate,
inserting a library ITM (and then later reconfiguring it if necessary) is often the most efficient way to
add an ITM to your Project Plan.
This section describes four scenarios for inserting library ITMs:
For illustration purposes, the same type of ITM (the "vds-id" ITM) is inserted in all scenarios.
However, the instructions apply equally to all ITMs.
Inserting a library ITM using the "default" library name
To insert an ITM from a library using the default name, do the following:
1.
Figure 6-49
Selecting the location in the device for the first library ITM
2.
4200-901-01 Rev. S / May 2017
• Inserting a library ITM using the "default" library name
• Inserting a library ITM using a new name
• Inserting multiple instances of a library ITM using the same name
• Inserting multiple instances of a library ITM using a different name
In the Project Navigator, select the Device Plan component below to insert the first ITM. To
add the first ITM to subsite_a of the u_build Project Plan, an appropriate component to
select is 4terminal-n-fet. See
Double-click the Device Plan name in the Project Navigator. The Device Plan window
appears, displaying a tree of device category folders. Each folder contains a list of device-
appropriate ITMs. See
Return to
Section 6: Keithley Interactive Test Environment (KITE)
section).
Figure 6-49.
Figure 6-50.
Section Topics
Submitting
6-59