Configuring A Load Balancing Action - Huawei S9700 Series Configuration Manual

S9700 Core Routing Switch
Configuration Guide - SPU
The system view is displayed.
Step 2 Run:
load-balance l7classifier l7classifier-name [ and | or ]
A Layer 7 classifier is created and the Layer 7 classifier view is displayed.
By default, no Layer 7 classifier is configured.
When you create a Layer 7 classifier, if and or or is not specified, the default matching mode
is and.
In egress link load balancing, the matching rule of a Layer 7 classifier can be set to only match
any. Therefore, any packet is matched regardless of whether the matching mode is and or or.
Step 3 (Optional) Run:
match any
The matching rule of the Layer 7 classifier is set to any, that is, any packet is matched.
after the matching rule is set to any, the traffic that is load balanced is processed at Layer 3 and
Layer 4. In this case, the load balancing algorithms for Layer 7 services including the hash
algorithm based on the URL cannot be configured.
By default, the matching rule of a Layer 7 classifier is any.
----End

6.3.7 Configuring a Load Balancing Action

This section describes how to create a load balancing action profile and specify an action.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
load-balance action action-name
A load balancing action profile is created and the load balancing action profile view is displayed.
Step 3 Run the following command as required.
l Run:
l Run:
l Run:
Issue 01 (2012-03-15)
NOTE
When you enter the Layer 7 classifier view, you can specify and or or. The specified matching mode must
be the same as the one used when the Layer 7 classifier is created.
drop
The action is set to drop.
forward
The action is set to forward.
group master-group-name [ backup backup-group-name ]
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 Load Balancing Configuration
199