Establishing The Configuration Task; Configuring The Poe Function Globally - Huawei Quidway S3700 Series Configuration Manual

Quidway S3700 Series Ethernet Switches
Configuration Guide - Device Management

9.3.1 Establishing the Configuration Task

Applicable Environment
The S3700 can detect whether a device connected to it needs the remote power supply and
provide power for the device that requires the remote power supply.
According to the actual requirements on the network, you can:
l
l
Pre-configuration Tasks
Before configuring the PoE functions, complete the following task:
Installing the PoE power supply on the S3700.

9.3.2 Configuring the PoE Function Globally

Procedure
l
l
l
Issue 01 (2011-07-15)
Set the maximum power and reserved power of the PoE power supply on the S3700 through
commands.
Control the remote power supply features of PoE interfaces separately, for example, enable
or disable the remote power supply function, and set the maximum output power, the power
supply mode, and the power supply priority through commands.
(Optional) Setting the maximum output power of the device.
1. Run:
system-view
The system view is displayed.
2. Run:
poe max-power maximum-power [ slot slot-id ]
The maximum output power of a board is set.
The value of maximum-power ranges from 15400 to 739200, in mW.
(Optional) Configuring the PoE power supply management mode
1. Run:
system-view
The system view is displayed.
2. Run:
poe power-management { auto | manual } [ slot slot-id ]
The power supply management mode is configured.
(Optional) Manually powering on or powering off the PD connected to an interface
NOTE
When the manual power management mode is adopted, you must manually power on or power off
PDs on interfaces.
1. Run:
system-view
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
9 PoE Configuration
120