Mitsubishi Electric MELSEC iQ-R Series Programming Manual page 1299

■Local work memory
The system uses this area as a work area.
To start the control from the initial status, clear data by using a sequence program.
Operand: (d2)
Device Symbol Name
+0  Last value input
(e1')
+1 Cycle counter
+2 Number of data
blocks stored in
the dead time
table
+3 Dead time table
+4 1
+5 Dead time table
+6 2
 
+2SN+1 Dead time table
+2SN+2 SN
*1 The cycle counter value is rounded off to the nearest whole number.
■Execution cycle (T)
Set the execution cycle (T) in SD816 and SD817 in single-precision real number.
Recommended range

*1
Data type Standard
value
 
11 PROCESS CONTROL INSTRUCTIONS
11.3 Control Operation Instructions
Set by
System
11
1297