Mitsubishi Electric MELSEC iQ-R Series Programming Manual page 1421

DMOV(P) [K8S/BL\K8S]
RnPCPU RnPCPU
RnCPU RnENCPU
(Process) (Redundant)
• The RnCPU and RnENCPU with firmware version "12" or later support this instruction. (Use an engineering tool with version "1.015R" or later.)
• The RnPCPU (process) with firmware version "03" or later supports these instructions. (Use an engineering tool with version "1.020W" or later.)
These instructions batch-read (in units of 32-bit binary data) the status (active or inactive) of steps in the specified block, and
store the read data in the specified device.
Ladder
(s) (d)
FBD/LD
EN ENO
s d
■Execution condition
Instruction
DMOV
DMOVP
Setting data
■Description, range, data type
Operand Description
(s) Device number where the transfer source data is stored
(d) Transfer destination device number
EN Execution condition
ENO Execution result
■Applicable devices
Operand Bit
X, Y, M, L, J\
SM, F, B, S,
SB, FX, FY
*1
 
(s)
(d)  
*1 Only S can be used.
RnSFCPU RnSFCPU
(Standard) (Safety)
Execution condition
Word
T, ST, C, D, W, U\G, J\,
SD, SW, FD, R, U3E\(H)G
ZR, RD
 
 
ST
ENO:=DMOV(EN,s,d);
ENO:=DMOVP(EN,s,d);
Range Data type
 32-bit signed binary

32-bit signed binary
 Bit

Bit
Double word Indirect
Z LT, LST, LZ
LC
  
  
13 SFC PROGRAM INSTRUCTIONS
Data type (label)
ANY32
ANY32
BOOL
BOOL
Constant Others
specification (BL\
K, H E $
S)
    
    
13.1 SFC Control Instructions
13
1419