Setting data
■Description, range, data type
Operand
Description
(s)
Device used as a contact
■Applicable devices
Operand
Bit
X, Y, M, L,
J\
SM, F, B, S,
SB, FX, FY
(s)
Processing details
• These instructions check whether the specified block is active or not.
• The status (on or off) of each contact will be as follows depending on the status (active or inactive) of the specified block.
Status of the specified block
Active
Inactive
• Specify the block No. within the range of 0 to 319. If the block No. specified is out of range, both of the normally open
contact and normally closed contact turn off.
• Execute the instruction only when an SFC program exists (SM320 is on) and SM321 is on.
Precautions
• When no SFC program exists (SM320 is off) or SM321 is off, the status (on or off) of the contact will be as follows:
Specified block No.
0 to 319
Less than 0, 320 or more (out of range)
Operation error
There is no operation error.
Range
Word
T, ST, C, D, W,
U\G, J\,
SD, SW, FD, R,
U3E\(H)G
ZR, RD
Contact of the normally open contact
instruction
On
Off
Contact of the normally open contact
instruction
Off
Off
Data type
Bit
Double word Indirect
specification
Z
LT, LST,
LZ
LC
Contact of the normally closed contact
instruction
Off
On
Contact of the normally closed contact
instruction
On
Off
13 SFC PROGRAM INSTRUCTIONS
13.1 SFC Control Instructions
Data type (label)
ANY_BOOL
Constant
Others
(BL)
K, H E
$
13
1415