Chapter 23 High Speed Data Logger Module Instructions; File Access Instructions; Recipe Write - Mitsubishi Electric MELSEC iQ-R Series Programming Manual

23
High Speed Data Logger Module Instructions
This chapter describes the instructions used commonly by MELSEC iQ-R series modules. When using
MELSEC-Q series modules, refer to the manual for each module used and create programs.
For precautions when using modules, refer to the following.
 MELSEC iQ-R Module Configuration Manual
23.1

File Access Instructions

Recipe write

Z(P).RCPWRITE
RnPCPU RnPCPU
RnCPU RnENCPU
(Process) (Redundant)
These instructions write the data in the CPU module to the specified recipe file in the SD memory card.
Ladder
(U) (s) (d)
FBD/LD
EN ENO
U d
s
■Execution condition
Instruction
Z.RCPWRITE
ZP.RCPWRITE
Setting data
■Description, range, data type
Operand Description
(U) Start I/O number (first three digits in four-digit hexadecimal
representation) of a module
(s) Start device where control data is stored
(d) Device that turns on for one scan upon completion of the
instruction
When the instruction completes with an error, (d)+1 also
turns on.
EN Execution condition
ENO Execution result
*1 When specifying setting data by using a label, define an array to secure enough operation area and specify an element of the array
label.
The local device and the file register for each program are not available for setting data.
RnSFCPU RnSFCPU
(Standard) (Safety)
Execution condition
ST
ENO:=Z_RCPWRITE(EN,U,s,d);
ENO:=ZP_RCPWRITE(EN,U,s,d);
Range Data type
00H to FEH String
Page 1782 Control data Device name

Bit
 Bit

Bit
23 High Speed Data Logger Module Instructions
Data type (label)
ANY16_OR_STRING_
SINGLE
*1
ANY16
ANYBIT_ARRAY
(Number of elements: 2)
BOOL
BOOL
1781
23.1 File Access Instructions
23