Receiving Data From The Programmable Controller On Another Station - Mitsubishi Electric MELSEC iQ-R Series Programming Manual

Receiving data from the programmable controller on another
station
JP.RECV, GP.RECV
RnPCPU
RnCPU RnENCPU
(Process)
These instructions read the data received from the programmable controller of another station (for the main routine program).
Ladder
(J/U)
FBD/LD
EN ENO
J/U d1
s d2
■Execution condition
Instruction
JP.RECV
GP.RECV
Setting data
■Description, range, data type
Operand Description
(J/U) JP.RECV (J): Own station network number
GP.RECV (U): Start I/O number (first three digits in four-digit
hexadecimal representation) of own station or own
node
(s) Own station start device where control data is
stored
(d1) Own station head device for storing the receive
data
(A continuous area for the receive data length is
required.)
(d2) Device of the own station, which turns on for one
scan upon completion of the instruction.
When the instruction completes with an error,
(d2)+1 also turns on.
EN Execution condition
ENO Execution result
*1 When specifying setting data by using a label, define an array to secure enough operation area and specify an element of the array
label.
15 NETWORK COMMON INSTRUCTIONS
1492
15.1 Link Dedicated Instructions
RnPCPU RnSFCPU RnSFCPU
(Redundant) (Standard) (Safety)
(s) (d1) (d2)
Execution condition
ST
ENO:=JP_RECV(EN,J,s,d1,d2);
ENO:=GP_RECV(EN,U,s,d1,d2);
Range Data type
1 to 239 16-bit unsigned binary
00H to FEH 16-bit unsigned binary
Refer to the control data. Device name

Device name

Bit
 Bit
 Bit
Data type (label)
ANY16
ANY16
*1
ANY16
*1
ANY16
ANYBIT_ARRAY
(Number of elements: 2)
BOOL
BOOL