Clearing Error Information - Mitsubishi Electric MELSEC iQ-R Series Programming Manual

16.6

Clearing Error Information

GP.ERRCLEAR, ZP.ERRCLEAR
RnPCPU RnPCPU
RnCPU RnENCPU
(Process) (Redundant)
These instructions turn off the LEDs and clear error information.
Ladder
(U) (s) (d)
FBD/LD
EN ENO
U d
s
*1 To turn off the LEDs, use the RJ71EN71 with a firmware version of "05" or later.
■Execution condition
Instruction
GP.ERRCLEAR
ZP.ERRCLEAR
Setting data
■Description, range, data type
Operand Description
(U) GP.ERRCLEAR Start I/O number (first three digits in four-digit
hexadecimal representation) of own station or own
node
ZP.ERRCLEAR Start I/O number (first three digits in four-digit
hexadecimal representation) of own station or own
node
(s) Start device of the own station where control data is
stored
(d) Device of the own station, which turns on for one
scan upon completion of the instruction.
When the instruction completes with an error, (d)+1
also turns on.
EN Execution condition
ENO Execution result
*1 When specifying setting data by using a label, define an array to secure enough operation area and specify an element of the array
label.
RnSFCPU RnSFCPU
(Standard) (Safety)
Execution condition
*1
ST
ENO:=GP_ERRCLEAR(EN,U,s,d);
ENO:=ZP_ERRCLEAR(EN,U,s,d);
Range Data type
00H to FEH 16-bit unsigned binary
00H to FEH String
Refer to the control data. Device name

Bit
 Bit

Bit
16 ETHERNET INSTRUCTIONS
16.6 Clearing Error Information
16
Data type (label)
ANY16
ANY16_OR_STRING_
SINGLE
*1
ANY16
ANYBIT_ARRAY
(Number of elements: 2)
BOOL
BOOL
1571