Writing Data To The Intelligent Device Station/Remote Device Station (32-Bit Address Specified) - Mitsubishi Electric MELSEC iQ-R Series Programming Manual

18.4
Writing Data to the Intelligent Device Station/
Remote Device Station (32-bit Address Specified)
JP.REMTOD
RnPCPU RnPCPU
RnCPU RnENCPU
(Process) (Redundant)
• The RnCPU and RnENCPU with firmware version "22" or later support this instruction. (Use an engineering tool with version "1.025B" or later.)
• The RnPCPU (process) and the RnPCPU (redundant) with firmware version "04" or later support this instruction. (Use an engineering tool with version
"1.025B" or later.)
• The RnSFCPU (standard) with firmware version "06" or later supports this instruction. (Use an engineering tool with version "1.025B" or later.)
• The RJ71GF11-T2 and RJ71EN71 with firmware version "12" or later support this instruction. (Use an engineering tool with version "1.025B" or later.)
This instruction writes data to the buffer memory area of the intelligent device station or the remote device station (in units of
words, 32-bit address specified).
Ladder
(J) (s1) (s2)
FBD/LD
EN ENO
J d
s1
s2
s3
s4
s5
n
■Execution condition
Instruction
JP.REMTOD
RnSFCPU RnSFCPU
(Standard) (Safety)
(s3) (s4) (n) (d)
(s5)
Execution condition

18.4 Writing Data to the Intelligent Device Station/Remote Device Station (32-bit Address Specified)

ST
ENO:=JP_REMTOD(EN,J,s1,s2,s3,s4,s5,n,d);
18 CC-LINK IE FIELD NETWORK INSTRUCTIONS
18
1615