Mitsubishi Electric MELSEC iQ-R Series Programming Manual page 1747

• Program example
(14) Set control data.
Save data types need not be set for the following modules.
• R60ADV8
• R60ADI8
• R60DAV8
• R60DAI8
• R60TD8-G
• R60RD8-G
(43) Read the offset/gain settings.
Precautions
In the following cases, the G(P).OGLOAD instruction will be disabled.
• The module has been set as a target of synchronization.
• The simultaneous conversion mode has been selected on the high speed analog-digital converter module.
• The wave output mode has been selected on the D/A converter module.
• The high-speed output mode has been selected on the high speed digital-analog converter module.
Operation error
Error code Description
((s)+1)
1863H The value set in the save data type setting 1 (S)+2 or the save data type setting 2 (s)+3 is out of the valid range.
21 A/D CONVERSION INSTRUCTIONS
21.2 Reading the User Range Setting Values
21
1745