Mitsubishi Electric MELSEC iQ-R Series Programming Manual page 810

Processing details
• These instructions convert the unit of the measure of angle from the degree specified by (s) to the radian, and store the
angle in radians in the device number specified by (d).
(s)+1 (s)
(
Single-precision real number
• Unit conversion from the degree to the radian is performed as follows.
π
Radian = Degree ×
180
• When an input value is set using the engineering tool, a rounding error may occur. Refer to the following for the precautions
on setting input values using the engineering tool.
Page 49 Precautions
Operation error
Error code Description
(SD0)
The value input to (s) is -0, a subnormal number, NaN (not a number), or .
3402H
3403H The data output from (d) exceeds the following range. (An overflow has occurred.)
|(d)|<2
7 APPLICATION INSTRUCTIONS
808
7.9 Real Number Instructions
(d)+1
)° (
Single-precision real number
128
(d)
) rad