Mitsubishi Electric MELSEC iQ-R Series Programming Manual page 1586

• The following figure shows the RSTOP instruction execution timing.
• When completed successfully
Sequence scan
Start contact
CPU module on
the own station
Completion device (d)
Completion status
indication device (d)+1
CC-Link IE
Controller
Network module
Network module
Sequence scan
CPU module on
the target station
Depending on the system configuration and sequence scan time, several scans may be required until the sequence scan STOP completes.
• When completed with an error
Sequence scan
Start contact
CPU module on
the own station
Completion device (d)
Completion status
indication device (d)+1
Link dedicated
instructions processing
result CH1 (SW0030)
CC-Link IE
Controller
Network module
• If the J.RSTOP, G.RSTOP, or Z.RSTOP is used to execute processing, processing of one time is successively followed by
the next processing while the start-up contact is on.
• If the JP.RSTOP, GP.RSTOP, or ZP.RSTOP is used to execute processing, processing is executed once at the start-up
contact off-to-on rise.
17 CC-LINK IE CONTROLLER NETWORK INSTRUCTIONS
1584
17.2 Remote STOP
RSTOP
0 END 0
ON
OFF
OFF
OFF
Channel n
0 END 0 END
Remote STOP
RSTOP
0 END 0
ON
OFF
OFF
OFF
Channel n
Target station error
END 0 END 0
ON
1 scan
Stopped
END 0 END 0
OFF
ON
ON
1 scan
END 0 END
OFF
OFF
END 0 END
OFF
OFF
Error code