Mitsubishi Electric MELSEC iQ-R Series Programming Manual page 1650

■Applicable devices
Operand Bit
X, Y, M, L,
SM, F, B, SB,
FX, FY
*1
(U) 

(s1)
(s2) 
*2

(d)
*1 Index modification is not available.
*2 FX and FY cannot be used.
*3 FD cannot be used.
*4 T, ST, C, and FD cannot be used.
■Control data
Operand: (s1)
Device Item
+0 Completion status
+1 Station number
+2 Access/attribute code
+3 Buffer memory address
or device number
+4 Number of write points
*1 When specifying a random accuracy buffer, specify the address with the start of the random accuracy buffer defined as 0.
*2 Specify a value within the capacity of the target station buffer memory area or device.
*3 If data is to be written to a CPU module device if the target station CPU module is other than RCPU, QCPU (Q mode), QCPU (A mode),
LCPU, QnACPU, or AnUCPU, the setting range is 1 to 32 words.
19 CC-LINK INSTRUCTIONS
1648
19.2 Writing Data to the Target Station
Word
J\ T, ST, C, D, W,
SD, SW, FD, R,
ZR, RD
 
*3
 
*3
 
*4
 
Description
The completion status is stored upon completion of the instruction.
• 0: Completed successfully
• Other than 0: Completed with an error (error code)
Specify the station number of the target station.
Specifies the type of the buffer memory or device from which to read data.
b15 ... b8 b7
• b8 to b15: Access code
• b0 to b7: Attribute code
Specifies the start address of the buffer memory area or the start device to which to
write data.
Specifies, in units of words, the number of points to be written.
Double word Indirect
U\G, J\, Z LT, LST,
U3E\(H)G LC
  
  
  
  
... b0
Constant
specification
LZ K, H E
   
   
   
   
Setting range

0 to 64
Refer to
"Access/attribute
code."
Refer to the
manual of the
*1
target station.
*2
1 to 480
*3
1 to 32
Others
(U)
$
 
 
 
 
Set by
System
User
User
User
User