Sending Data Using The Nonprocedural Protocol - Mitsubishi Electric MELSEC iQ-R Series Programming Manual

20.3

Sending Data Using the Nonprocedural Protocol

G(P).OUTPUT
RnPCPU
RnCPU RnENCPU
(Process)
These instructions send data in a user-defined message format by using the nonprocedural protocol.
Ladder
(U)
FBD/LD
EN ENO
U d
s1
s2
■Execution condition
Instruction
G.OUTPUT
GP.OUTPUT
Setting data
■Description, range, data type
Operand Description
(U) Start I/O number (first three digits in four-digit hexadecimal
representation) of a module
(s1) Start device where control data is stored
(s2) Start device where the send data is stored
(d) Device that turns on for one scan upon completion of the
instruction
When the instruction completes with an error, (d)+1 also
turns on.
EN Execution condition
ENO Execution result
*1 When specifying setting data by using a label, define an array to secure enough operation area and specify an element of the array
label.
20 SERIAL COMMUNICATION INSTRUCTIONS
1682
20.3 Sending Data Using the Nonprocedural Protocol
RnPCPU RnSFCPU RnSFCPU
(Redundant) (Standard) (Safety)
(s1) (s2) (d)
Execution condition
ST
ENO:=G_OUTPUT(EN,U,s1,s2,d);
ENO:=GP_OUTPUT(EN,U,s1,s2,d);
Range Data type
00H to FEH 16-bit unsigned binary
Refer to the control data. Device name

Device name

Bit

Bit
 Bit
Data type (label)
ANY16
*1
ANY16
*1
ANY16
ANYBIT_ARRAY
(Number of elements: 2)
BOOL
BOOL