Reading The Module Status Information Of An Intelligent Device Station - Mitsubishi Electric MELSEC iQ-R Series Programming Manual

18.6
Reading the Module Status Information of an
Intelligent Device Station
J(P).SINFSTRD, G(P)SINFSTRD
RnPCPU
RnCPU RnENCPU
(Process)
• The RnENCPU (network part), RJ71GF11-T2, and RJ71EN71 with firmware version "12" or later support these instructions. (Use an engineering tool with
version "1.025B" or later.)
These instructions read the status information of modules and units used in an intelligent device station.
Ladder
(J/U)
FBD/LD
EN ENO
J/U d1
s d2
■Execution condition
Instruction
J.SINFSTRD
G.SINFSTRD
JP.SINFSTRD
GP.SINFSTRD
Setting data
■Description, range, data type
Operand Description
(J/ J(P).SINFS (J): Own station network number
U) TRD
G(P).SINFS (U): Start I/O number (first three digits in four-digit
TRD hexadecimal representation) of own station or own
node
(s) Start device of the own station where control data is
stored
(d1) Start device of the own station for storing the read
data (A continuous area of 356 words is required.)
(d2) Device of the own station, which turns on for one
scan upon completion of the instruction.
When the instruction completes with an error, (d2)+1
also turns on.
EN Execution condition
ENO Execution result
*1 When specifying setting data by using a label, define an array to secure enough operation area and specify an element of the array
label.
18 CC-LINK IE FIELD NETWORK INSTRUCTIONS
1624

18.6 Reading the Module Status Information of an Intelligent Device Station

RnPCPU RnSFCPU RnSFCPU
(Redundant) (Standard) (Safety)
(s) (d1) (d2)
Execution condition
ST
ENO:=J_SINFSTRD(EN,J,s,d1,d2);
ENO:=JP_SINFSTRD(EN,J,s,d1,d2);
ENO:=G_SINFSTRD(EN,U,s,d1,d2);
ENO:=GP_SINFSTRD(EN,U,s,d1,d2);
Range
1 to 239
00H to FEH
Refer to the control data.




Data type Data type (label)
16-bit unsigned binary ANY16
16-bit unsigned binary ANY16
Device name ANY16
Device name ANY16
Bit ANYBIT_ARRAY
(Number of elements:
2)
Bit BOOL
Bit BOOL
*1
*1