Reading Data From The Intelligent Device Station/Remote Device Station (32-Bit Address Specified) - Mitsubishi Electric MELSEC iQ-R Series Programming Manual

18.3
Reading Data from the Intelligent Device Station/
Remote Device Station (32-bit Address Specified)
JP.REMFRD
RnPCPU
RnCPU RnENCPU
(Process)
• The RnCPU and RnENCPU with firmware version "22" or later support this instruction. (Use an engineering tool with version "1.025B" or later.)
• The RnPCPU (process) and the RnPCPU (redundant) with firmware version "04" or later support this instruction. (Use an engineering tool with version
"1.025B" or later.)
• The RnSFCPU (standard) with firmware version "06" or later supports this instruction. (Use an engineering tool with version "1.025B" or later.)
• The RJ71GF11-T2 and RJ71EN71 with firmware version "12" or later support this instruction. (Use an engineering tool with version "1.025B" or later.)
This instruction reads data from the buffer memory area of the intelligent device station or the remote device station (in units
of words, 32-bit address specified).
Ladder
(J)
FBD/LD
EN ENO
J d1
s1 d2
s2
s3
s4
n
■Execution condition
Instruction
JP.REMFRD
18 CC-LINK IE FIELD NETWORK INSTRUCTIONS
1610

18.3 Reading Data from the Intelligent Device Station/Remote Device Station (32-bit Address Specified)

RnPCPU RnSFCPU RnSFCPU
(Redundant) (Standard) (Safety)
(s1) (s2) (s3) (s4) (d1)
Execution condition
ST
ENO:=JP_REMFRD(EN,J,s1,s2,s3,s4,n,d1,d2);
(n) (d2)