Table of Contents
Advertisement
JRR200 Route Reflector Hardware Guide
Replacing the JRR200 Route Reflector DC Power Supply
58
Figure 17: Installing an AC Power Supply
Each DC power supply is a field-replaceable unit (FRU) installed in the rear panel of
JRR200 route reflector. You can remove and replace the power supplies without powering
off JRR200 route reflector or disrupting route reflector functions.
NOTE:
All the power supplies must be installed and operational for optimal
functioning of JRR200 route reflector.
Removing a JRR200 Route Reflector DC Power Supply on page 58
Installing a JRR200 Route Reflector DC Power Supply on page 59
Removing a JRR200 Route Reflector DC Power Supply
Ensure that you have the following parts and tools available:
ESD grounding strap
Phillips (+) screwdriver, number 2
Antistatic bag or an antistatic mat
Replacement power supply
To remove a DC power supply (see
Place the antistatic bag or the antistatic mat on a flat, stable surface.
1.
Attach the ESD grounding strap to your bare wrist, and connect the strap to the ESD
2.
point on the chassis.
Make sure that the voltage across the DC power source cables leads is 0 V and that
3.
there is no chance that the cables might become active during the removal process.
Remove the plastic cover from the input terminals by sliding the cover either to the
4.
left or right.
Figure 18 on page
59):
Copyright © 2018, Juniper Networks, Inc.
Advertisement
Table of Contents
Troubleshooting
