Table of Contents
Advertisement
PTX10016 Router Quick Start Guide
Step 3–Mounting the Router Chassis
Installing the Mounting Hardware
8
To install the PTX10016, first install the mounting hardware and then use a mechanical
lift to load the chassis into the rack.
Installing the Mounting Hardware on page 8
Mounting the PTX10016 Using a Mechanical Lift on page 10
Install the mounting hardware on the rack before installing the router. The PTX10016
comes with a four-piece set of mounting brackets that support the chassis in the rack.
NOTE:
Two-post installation racks are not supported.
The four mounting bracket pieces are:
1 left front mounting bracket. The bracket is labeled "LEFT FRONT" on the side of the
bracket that faces the interior of the rack, near the holes for attaching the bracket to
the rack.
1 right front mounting bracket. The bracket is labeled "RIGHT FRONT" on the side of
the bracket that faces the interior of the rack, near the holes for attaching the bracket
to the rack.
2 rear mounting brackets. These brackets are labeled "REAR" on the side of the bracket
that faces the interior of the rack, near the holes for attaching the bracket to the rack.
The rear brackets are interchangeable; you can use either of the rear brackets with the
right or left front-mounting bracket.
Ensure that you have the following parts and tools available to install the mounting
brackets:
A Phillips (+) screwdriver, number 1, 2, or 3, depending on the size of your rack-mounting
screws
A Phillips (+) screwdriver, number 2, to install the screws that connect the
rear-mounting and front-mounting brackets
16 mounting screws appropriate for your rack to attach the 4 mounting bracket pieces
to the rack
When you install the mounting brackets, the adjustable portion of the brackets overlap.
Use the overlap area to adjust the total bracket length to fit any of the four standard rack
sizes: 19 in. (483 mm), 23.62 in. (600 mm), 30 in. (762 mm), or 31.5 in. (800 mm).
Copyright © 2018, Juniper Networks, Inc.
Advertisement
Table of Contents
