Pinout Specifications; Rj-45 Connector Pinouts For Mx Series Cb-Re Auxiliary And Console Ports; Table 47: Rj-45 Connector Pinout For The Auxiliary And Console Ports; Chapter 12 Pinout Specifications - Juniper MX2020 Hardware Manual

CHAPTER 12

Pinout Specifications

RJ-45 Connector Pinouts for MX Series CB-RE Auxiliary and Console Ports

Related
Documentation
Copyright © 2015, Juniper Networks, Inc.
RJ-45 Connector Pinouts for MX Series CB-RE Auxiliary and Console Ports on page 145
RJ-45 Connector Pinouts for an MX Series CB-RE Management Port on page 146
The ports on the Control Board and Routing Engine (CB-RE) labeled
are asynchronous serial interfaces that accept an RJ-45 connector. The ports connect
the Routing Engine to an auxiliary or console management
describes the RJ-45 connector pinout.

Table 47: RJ-45 Connector Pinout for the Auxiliary and Console Ports

Pin Signal
1 RTS
2 DTR
3 TXD
4 Ground
5 Ground
6 RXD
7 DSR/DCD
8 CTS
MX2020 Host Subsystem Description on page 57
Removing an MX2020 CB-RE on page 419
Installing an MX2020 CB-RE on page 301
CB-RE Interface Cable and Wire Specifications for MX Series Routers on page 130
and
AUX CONSOLE
device.Table 47 on page 145
Description
Request to Send
Data Terminal Ready
Transmit Data
Signal Ground
Signal Ground
Receive Data
Data Set Ready
Clear to Send
145