Programming; Primary Infusion - With Guardrails; Suite Mx Protection - Cardinal Health Alaris Directions For Use Manual

References throughout this procedure to specific drugs and
drug doses are for illustration purposes only. Reference
specific drug product labeling for information concerning
appropriate administration techniques and dosages.
See "General Information", "Features and Displays" and the
PC Unit Section of this DFU for information about:
• Displays
• Operating Features, Controls, Indicators
The majority of user interface programming is identical for both
the Pump Module and Syringe Module. When referring to both
modules, the term "infusion modules" is used.
Primary Infusion
The following procedures are to be used only when the drug
to be infused is listed in the Drug Library. To access the Drug
Library, a hospital-defined best-practice Data Set must be
transferred using the Editor Software and the Profiles feature
must be enabled.
1. Perform following steps (see PC Unit Section of this DFU,
"General Setup and Operation", "Start-Up"):
a. Power on system.
Choose Yes or No to New Patient?
b.
c. Confirm current profile or select a new profile.
d. Enter patient identifier, if required.
2. Prepare and load syringe/administration set (see "Getting
Started").
3. Prime (see "Getting Started").
®
Alaris System (with v9 Model 8000) DFU
Pump and Syringe Modules Section
- With Guardrails
®

Suite MX Protection

WARNING
When the pressure sensing
disc is not being used and an
occlusion occurs, there is a risk
of infusing pressurized buildup
of infusates upon correction of the
occlusion. To avoid an inadvertent
bolus, relieve the pressure before
restarting the infusion.

Programming

FU
FU
RATE (mL/h)
RATE (mL/h)
CHANNEL
SELECT
CHANNEL
SELECT
PAUSE
PAUSE
CHANNEL
OFF
CHANNEL
OFF
RESTART
RESTART
FU
RATE (mL/h)
CHANNEL
SELECT
PAUSE
CHANNEL OFF
RESTART
2-21
Programming