Configuration - BONFIGLIOLI Agile Operating Instructions Manual

Parameter descriptions
1 - Parameters for quick commissioning.
2 - The parameters most used can be set.
3 - All parameters can be set.
7.1.2

Configuration

30 Configuration
The 30 determines the control behavior with which the electric motor is controlled. The
Configuration
operating instructions describe the following configurations and the relevant parameters in the third
28 (adjustment of parameter
Control level
Configuration 110, IM
Configuration 110 contains the functions for variable-speed control of an asynchronous motor in a
wide range of standard applications (e.g. for control of fans and pumps). The motor speed is set ac-
cording to the V/f characteristic in accordance with the voltage/frequency ratio.
Configuration 410, IM: sensor-less field-orientated control (DMC)
Configuration 410 contains the functions for sensor-less, field-orientated control of an asynchronous
motor. The current motor speed is determined from the present cur-rents and voltages in combination
with the motor parameters. Separate control of torque and flux-forming current enables high drive
dynamism at a high load moment. In this configuration, parallel connection of several 3-phase motors
is possible to a limited extent only.
Configuration 610, PMSM
Configuration 610 contains the functions for sensor-less, field-orientated control of a synchronous
motor. The current motor speed is determined from the present cur-rents and voltages in combination
with the motor parameters. Separate control of torque and flux-forming current enables high drive
dynamism at a high load moment. This configuration is intended for the connection of a single motor.
Parallel connection of several synchronous motors is not intended and possible to a very limited extent
only.
Function
Speed control
Torque control
Switch-over speed/torque control
Dynamic voltage pre-control
Intelligent current limits
Voltage controller
PID controller (technology controller)
Slip compensation
Current limit value controller
Current controller
Acceleration pre-control
Field controller
1
Asynchronous motor
2
Direct moment control
3
Permanently excited synchronous motor.
Inverter Data
28
Control level
Control level
1
: sensor-less control
3
: sensor-less field-orientated control (DMC)
Chapter
7.9.5.3
7.9.5.2
7.6.6.10
7.8.1
7.9.1
7.9.2
7.9.3
7.9.4.1
7.9.4.2
7.9.5.1
7.9.5.4
7.9.5.5
Selection on operator panel
Easy
Standard
Professional
28 to value 3).
Configuration
Asynchronous motor
V/f character-
istic
110
x
x
x
x
x
x
x
x
111
06/2013 Operating Instructions
2
Synchronous
motor
Field-orientated control
410 610
x x
x x
x x
x x
x x
x x
x x
x x
x x
Agile