BONFIGLIOLI Agile Operating Instructions Manual page 58

Poti P - variable percentage reference value
The function Poti P is applicable for operation with variable percentage values, in example this is used
with the technology controller and the direct torque control.
Select one of the following settings for parameter
− 3 - Control via keypad
− 4 - Control via keypad or contacts (factory setting)
Select "5 - Keypad motor potentiometer"
•
Reference percentage source 2
Switch on enable signals at digital inputs STOA (terminal X11.3) and STOB (terminal X13.3).
•
Select  via arrow keys. Confirm by pressing ENT.
•
Select via arrow keys. Confirm by pressing ENT.
•  
Start drive RUN
The displayed reference value is the sum of
476 and
Operation
mode
Set per- Increase percentage value.
centage
Decrease percentage value.
value
− Press for a short time to change the frequency by increments of 0.1%.
− Keep pressed to change the percentage value by
The change of sign can occur if
Minimum reference percentage
limit the setting range.
RUN ENT
Change sign
Display of drive status:
The reference percentage value at rotating drive. The reference percentage val-

ue is the sum of
source 2
The drive is stopped. The alternating display shows the reference percentage
value and the message STOP.
1
Factory setting of parameter
value can be set via operator panel (keypad).
2
In the factory setting the reference percentage value can be positive or negative.
Agile
Operating Instructions
Local/Remote
1
for parameter
494.
Reference percentage source 2
0 - Off: 0%.
2
495 :
1 - The reference value can be both positive and negative.
2 - Positive only.
3 - Inverted.
509 (factory setting: 10%/s).
Motorpoti
The sign of the reference percentage value changes. Only possible for
torque control (parameter n-/T-Control Change-Over 164).
Reference percentage source 1
494.
Reference frequency source 2
58
06/2013
412:
Reference percentage source 1
Reference percentage source 1
494.
Ramp Percentage-
418 is set to 0 Hz.
Minimum Frequency
518 and
Maximum reference percentage
476 and
Reference percentage
492. In the factory setting the reference frequency
Commissioning
476 or
519
Operator panel