Digital Outputs - BONFIGLIOLI Agile Operating Instructions Manual

Parameter descriptions

7.6.5 Digital outputs

531 Operation Mode OUT1D (X13.5) (Digital output)
532 Operation Mode OUT2D (X10/relay)
533 Operation Mode OUT3D (X11.6) (Digital input/output)
554 Digital: Source MFO1D (Multifunction output)
The digital signals listed in table "Operation modes for digital outputs" can be output via:
− Digital output
− Multifunction output (set as digital output)
− Digital input/output (set as digital output)
− Relay output
If the multifunction output or digital input/output is to output a digital value, the relevant output must
be set up as a digital output:
Output Terminal
Multifunction
X13.6
output
Digital in-
X11.6
put/output
Factory settings of digital outputs
Output Terminal
Digital out-
X13.5
put
Multifunc-
X13.6
tion output
Digital in-
X11.6
put/output
Relay out-
X10
put
NOTE
The relay output at terminal X10 is switched off if the communication between control
and power circuitry of the frequency inverter is faulty. This avoids dangerous conditions
for example in the brake control of hoist applications.
Operation modes for digital outputs
Operation mode 531, 532, 533, 554
0 - Off
1 - Ready or Standby Signal
2 - Run Signal
3 - Error Signal
4 - Setting Frequency
5 - Reference Frequency reached
6 - Reference Percentage reached
Control inputs and outputs
Parameters
Operation Mode MFO1
550
(X13.6)
Operation Mode Termi-
558
nal X11.6
Parameters
Operation Mode OUT1D (X13.5)
Digital: Source MFO1D
Operation Mode OUT3D (X11.6)
Operation Mode OUT2D (X10/relay)
Digital output is switched off
Frequency inverter is initialized and on stand-by or in
operation
Enable signals STOA and STOB and a start command
are present, output frequency available.
The message is displayed via parameter
259.
The
Stator frequency
ized
Setting frequency
"Setting frequency".
The
Actual frequency
Internal reference frequency
"Reference value reached".
The
Actual percentage
percentage
reached".
187
Factory setting
Analog
10 - (PWM)
MFO1A
0 - Input IN3D
Factory setting
531
2 -
554
4 -
533
103 -
532
103 -
Function
210 is higher than the parameter-
510. See chapter 7.6.5.2
241 of the drive has reached the
228. See chapter 7.6.5.3
230 has reached the
229. See chapter 7.6.5.3 "Reference value
06/2013 Operating Instructions
Set
Digital
1 -
MFO1D
Output
1 -
OUT3D
Run signal
Setting frequency
Inv. error signal
Inv. error signal
Actual error
Reference
Agile