BONFIGLIOLI Agile Operating Instructions Manual page 252

48 Reference Frequency
For traverse mode, the reference value source is selected via parameter
Traverse mode becomes active when
values for
Ramp-up Time
0 - Ramp output (factory setting)
1 ... 5 - Fixed frequencies 1 ... 4
9 - Zero
10 - Stator frequency
12 - Tech. controller freq. output
14 - Traverse function output
16 - I-limit output
21 - Rotor frequency
50 - Reference analog value MFI1A
51 - Reference analog value MFI2A
56 - PWM Input
62 - Reference frequency channel
Attention:
WARNING
The frequency range for traverse mode is added additional to the frequency reference.
Therefore the added frequency can result in values smaller than
418 or bigger than
To prevent too high frequencies, the summed frequency is limited:
Maximum Frequency
419 <= 100 Hz
Maximum Frequency
419 >= 100 Hz
Maximum Frequency
Traverse function with Setting
Agile
Operating Instructions
Operation Mode
436 and
Ramp-down Time
Reference Frequency
115 ... 118 - Fixed frequencies 5 ... 8
708 ... 738 - RxPDO Long (system bus)
774, 775 - Out-F PDPconv-long (Profibus)
2501 ... 2504 - PLC-output frequency 1 ... 4
Maximum Frequency
419 Limitation of the summed Frequency
Maximum Frequency
Maximum Frequency
Reference Frequency
252
06/2013
Reference Frequency
435 is switched on. In traverse mode, the
437 are active.
48
93 - Slip compensation
109 - Udc-controller
154 - Reference ramp value
155 - Actual speed
230 - Internal reference frequency
288 - Repetition frequency input
688 - Electronic gear output
419.
419 +20 Hz
419 x 1.2
48 0 – Ramp output:
Parameter descriptions
48.
Minimum Frequency
Special functions