BONFIGLIOLI Agile Operating Instructions Manual page 66

Parameter
Please note: If you changed the configuration, the device resets.
Please execute the before mentioned steps anew.
− BCR-motor series of Bonfiglioli Vectron
− BTD- motor series of Bonfiglioli Vectron
− Other synchronous servo motor
Enter motor data according to the name plate:
Standstill Torque M0 in Nm
Set the value using the arrow keys.
Note
Press the arrow keys for 1 s to set each figure individually.
P371 Rated current in A
If a BCR or BTD motor of Bonfiglioli Vectron was selected, the follow-
ing data are preselected based on the standstill torque and the rated
current. If a BONFIGLIOLI motor is connected check and confirm the
values. If a motor of another manufacturer was connected, please
enter the values manually.
P370 Rated voltage in V
The real AC rated voltage of the motor has to be set up (marked bold
in the following). This results in entering:
AC 330 V Motor
AC 200 V Motor
P376 Rated mechanical power in kW.
For the BCR and BTD motors, the rated mechanical power is listed in
the motor catalogue.
P372 Rated speed in rpm.
P373 No. of pole pairs
P375 Rated frequency in Hz
If "STO" is displayed, enable must be switched on via STOA (X11.3)
and STOB (X13.3).
Auto-tuning (auto set-up). Confirm to start the measurement of fur-
ther motor parameters. Consider the following note for another set-
1
Control of a synchronous motor, for higher demands on speed or torque accuracy. In the case of control via
operator panel: Select "Synch". PMSM: Permanently magnetized synchronous motor.
Agile
Operating Instructions
= DC 560 V Motor = AC 400 V FI System voltage
= DC 320 V Motor = AC 230 V FI System voltage
66
06/2013
Commissioning
Display
ENT

oder

oder

ENT
  .
ENT
1 s

ENT

ENT
 
ENT

ENT
 
.
ENT

ENT


First commissioning