Technical Data; General Technical Data - BONFIGLIOLI Agile Operating Instructions Manual

Technical data

11 Technical data
This chapter contains the technical data of the Agile series.
11.1

General technical data

CE conformity The frequency inverters
2006/95/EEC and EN 61800-5-1.
EMC directive For compliance with standard 2004/108/EC, comply with installation instructions
in this document.
Interference im- The frequency inverters
munity industrial environments.
UL Approval Devices that are marked with the UL proof label fulfill the requirements according
to UL508c.
Ambient tempera-
ture Operation: 0...55 °C; as from 40 °C power reduction should be considered.
Environmental class Operation: 3K3 (EN60721-3-3),
maximum relative humidity 85%, no water condensation.
Degree of protec- IP20 if covers and connection terminals are used properly.
tion
Altitude of installa- Up to 1000 m at rated specifications.
tion Up to 3000 m at reduced power.
Storage Storage according to EN 50178.
BONFIGLIOLI recommends that the unit be connected to mains voltage for 60
minutes after one year, at the latest.
Overload capacity Continuous operation 100% I
(o ) Up to 150% I
c
Up to 200% I
Overload capacity can be used every 10 minutes.
Functions
− Control methods adjusted to motors and application (configuration)
− Adjustable speed/torque control
− Various protection functions for motor and frequency inverter
− Positioning relative to a reference point
− Flying Start function
− S-ramps for jerk limitation during acceleration and deceleration
− PID controller (technology controller)
− Parameterizable Master-Slave operation via system bus
− Error memory
− Simplified and extended control via PC (commissioning, parameterization, data
set backup, diagnosis with Scope)
− Energy saving function
− Automatic service messages
− Self-learning controllers
− Communication: System bus, CANopen®, Modbus and VABus. Profibus with
optional communication module.
Parameterization
− Freely programmable digital inputs and outputs
− PLC functions, can be realized via table functions or a graphical PC user inter-
face
− Four separate data sets incl. motor parameter
− Pre-defined motor data BONFIGLIOLI motors
General technical data
Agile
meet the requirements of the low voltage directive
Agile
meet the requirements of EN 61800-3 for use in
N
for 60 s
N
for 1 s
N
277
06/2013 Operating Instructions
Agile